1. Temperature of heat rejection in a condenser can be lowered by using?
a) lubricant
b) oil
c) refrigerant
d) diesel
Explanation: A refrigerant in the form of coolant is used to lower the temperature of heat rejection.
2. The use of which of the following becomes necessary during expansion of steam?
a) reheat
b) regeneration
c) refrigeration
d) superheat
Explanation: In order to obtain a higher temperature of heat addition, heat moisture content is involved during expansion of steam. The use of reheat thus becomes necessary.
3. Which is the drawback of the steam as a working substance in a power cycle?
a) in a vapour power cycle, maximum temperature which can be obtained with best available material is more than the critical temperature of water and requires large superheating
b) it allows only small amount of heat addition at the highest temperature
c) it requires reheat and reheater tubes are costly
d) all of the mentioned
Explanation: All the drawbacks mentioned are correct.
4. For maximum efficiency of vapour power cycle, what should be the critical temperature of working fluid?
a) the working fluid should have critical temperature as low as possible
b) the working fluid should have critical temperature as high as possible
c) the critical temperature does not affect the efficiency of the vapour power cycle
d) none of the mentioned
Explanation: More the critical temperature, more efficient will be the working.
5. What is the specific heat of the ideal working fluid used in vapour power cycle?
a) should be constant
b) should be large
c) should be small
d) none of the mentioned
Explanation: The specific heat of a fluid is the amount of energy the fluid takes in heating water for 1 degree Celsius.
6. What is the importance of the freezing point of the working fluid in the vapour power cycle?
a) freezing point of working fluid should be below the room temperature
b) freezing point of working fluid should be above the room temperature
c) freezing point of working fluid should be equal to the room temperature
d) does not have any importance
Explanation: For the efficient working of a working fluid, its freezing point should be below the room temperature.
7. When two vapour cycles are coupled in series and heat rejected by one is absorbed by another, the cycle is called as?
a) Dual vapour cycle
b) Binary vapour cycle
c) Coupled vapour cycle
d) None of the mentioned
Explanation: Binary vapour cycle is a cycle where two vapour cycles are coupled in series and heat rejected by one is absorbed by another.
8. The engines which are operating on gas power cycle are?
a) cyclic
b) non-cyclic
c) either cyclic or non-cyclic
d) none of the mentioned
Explanation: The cyclic nature is totally dependent on power cycle; it can be cyclic as well as non-cyclic depending on the gas power cycle.
9. Rankine cycle efficiency of a good steam power plant may be in the range of ___________
a) 15 to 20%
b) 35 to 45%
c) 70 to 80%
d) 90 to 95%
Explanation: The efficiency of a Rankine cycle lies in the range of 35-45 percent mostly.
10. Rankine efficiency of a steam power plant ___________
a) improves in summer as compared to that in winter
b) improves in winter as compared to that in summer
c) is unaffected by climatic conditions
d) none of the mentioned
Explanation: Rankine cycle efficiency depends upon condenser temperature.